How do I apply the GLASSGUARD™ Glass Nanocoat KitUpdated a year ago

Make sure the area is well ventilated before use. We encourage you to wear a mask, gloves and goggles while applying the nanocoat.

• Ensure that the surface is clean and dry before application, including removing any stains, mould or mineral build up.
• Treat 1-3m² at a time and spray the nanocoat over the surface until it is evenly and completely covered. You should only require 2-3 sprays for this area.
• Wipe over the sprayed area using the supplied microfibre cloth, being sure to spread the product evenly over the entire surface.
• Continue to work the product into the surface in a circular motion until it is completely dry. This may take up to 30 seconds.
• For optimal effect, keep the area dry for the next 12-24 hours, while the product sets. This will ensure you get your full 5+ year protection.

IN CASE OF FAILED APPLICATION: If you have applied the Nanocoat incorrectly and notice 'grit', residue, or swirling marks, use a strong alcohol-based cleaner or methylated spirits (found at most hardware stores or supermarkets) to remove the Nanocoat. Afterward, you can reapply the Nanocoat by following the instructions above carefully.

WARNING: Do not ingest. Keep out of reach from children and pets. Avoid contact with eyes. If contact with eyes occurs, wash out thoroughly with water. If irritation persists, seek medical assistance.